2 Commits

Include renames

Author	SHA1	Message	Date
glenn schrooyenandClaude	75195f7073	UX-54 round 2: tomorrow's blocks where control will act, trust as the plan counts it, strings ... F1: tomorrow's blocks no longer depend on the battery's level now. Home sizes a block from the level now (`room()`, `plan_need()` in mode_runs, the leg sizing in trade_runs) and draws none when there is no room or energy. For a day that has not started the builders take `ahead=True` (Home never passes it): a charge is read from the floor, a give from the ceiling. A grid block is then kept only where `modetrade.chargers()` would charge at the curve's level when the run starts. The UX-53 gate is unchanged. Today still equals Home; a give run in the plan with no block (empty battery) has its own sentence instead of "No charge or give blocks planned". F2: test_ux54.py part 7 walks the real `_mode_roles()` every 15 minutes through tomorrow and compares the roles with the tab's blocks (modes on, the peak gate, part-full batteries), and the control cycle's verdict at 07:00 (modes off). F3: the curve counts spare solar as trust x max(0, sun - house), stored at EFF, as `dayplan.plan()` does (10 kWh sun, 2 kWh house, 70 %: 5.32 kWh). Strings: cycle, no_tomorrow, ahead, no_level, measured; new give_later. No decision, command, timing or option key changes. Co-Authored-By: Claude <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_01Bdqr7PiaHcBnzPituu2yTC	2026-10-26 22:48:48 +01:00
glenn schrooyenandClaude	b6b2d1b184	UX-54: a Forecast tab with the sun, the house and each battery's level, per hour ... A new tab beside Home and Batteries for today and tomorrow: the solar forecast, the solar measured so far, the house's expected use and each battery's expected level, with the plan's own charge and give blocks under it. - Blocks are Home's: today's are the plan's `runs`, tomorrow's come from the same builders (`homeview.runs_for()`), in the plan lines' words. - The sun is what solarfc reads; a daily total is spread over the bell and the tab says so. The house is HouseProfile.estimator(), as the plan reads it. - The level is new: `daycurve.curve()` gives each battery the role `modetrade.decide()` gives it and moves it hour by hour inside the plan's floor and ceiling. It is an estimate and counts on `solar_trust_pct`. - Built on request (`GET forecast`), no Home Assistant call. Measured solar is kept per hour in memory from the reading control already takes. - A part not known yet is a note: modes off, no forecast, learning, no forecast for tomorrow, a monthly cycle, no level, stopped, shadow. No decision, command, timing or option key changes. Found, not changed: `dayplan.plan()` over-counts a state-only forecast (DECISIONS/UX-54). Co-Authored-By: Claude <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_01Bdqr7PiaHcBnzPituu2yTC	2026-10-26 19:38:59 +01:00